Toyota Check systems

AutoHex Diagnostic scan tool (HexDiag) Toyota software will automatically detect the control units equipped in the vehicle, and give you the status of all the control units if it was faulted or not, and automatically test and show up sequentially the systems included in this Category on the left menu, and you will see pop up message showing the tested system, with marks beside every systems defining its status:

• (V) For (NO fault codes)
• (X) For (with fault codes)
• (?) If there is no available information about this system or there is a defect in this ECU.

On the bottom of the right menu you will see new button (Quick Erase) enable you to erase fault codes of all the faulted systems.
Note:
After using (Quick Erase) button , the faulted systems on the left menu will move to the right menu and if the system still has fault codes its status will be (NOT OK) otherwise it becomes (OK).
the Original scan tool do not have options (Quick Test) and (Quick Erase) Control UnitsIf you did not choose Quick test you can select the system you like to test within these three categories
1. Drive
2. Chassis
3. Body